Use Hyper Terminal for update firmware.
1.As for total station,go to fileman,then download.
2.Input the pin code 82543,total station will shutdown.
3.Run the Hyper Terminal,connect to total station when prompted.
4.Update firmware by steps.

you must use Hyper Terminal to update firmware.
1.As for total station,go to fileman,then download.
2.Input the pin code 82543,total station will shutdown.
3.Run the Hyper Terminal,connect to total station when prompted.
4.Upgrade firmware by steps.

There are manual about the software to transfer the data.

1.Install driver of data transmission.
2.Transmit data through RS232C communication line.
3.Transmit data through the SD card.
4.Transfer data through USB disk.
5.Transfer data through MiniUSB communication cable.

1.Level total station, put a reflector 30m forward.
2.Switch on the instrument,turn on the laser.
3.Aim at the center of the reflector.
4.Remove the cover in the red frame below.
5.Adjust the triax.
6.Fix the cover back.

Please refer to relevant file below.

1.Set paramaters with total station.
2.Device connect with total station.
3.Do survey work and collect the point on the device.
More detailed operation refer to relevant file.

1.Click the"Start"and then click"Setting"icon.
2.Click"System"icon.
3.Click"Remove Programs"icon.
4.Highlight the software and click"Remove"button.
5.Click"Yes"to confirm. Then the un-installation begin.

1.Install Hi-Target Geomatics Office(HGO) software on your PC.
2.Download the data from Hi-Target GNSS receiver to PC.
3.Run HGO software, click"Tools"on he menu, and click"Rinex Convert Tool".
4.Click"Open"button to import Hi-target format static files(*.ZHD,*.GNS).
5.Set the parameters(Rinex Version,marker name, antenna height and so on) Then click"Convert"button to convert.

1.New a project and input the project info.
2.Define the coordinate system.
3.Click【Import Files】, import the observe file.
4.Add station coordinate.
5.Calculating the stop-go data.
6.Check the calculating report.

1.Copy the grid file to the “GEOpath” (File format “.GRD”).
2.Open Hi-RTK and click "Setting" to get into interface.
3.Click "model"to chose the grid file in tab "Height Fitting".
4.Click save.

1.Run the Hi-RTK and open a project.
2.Go to the Setting interface.
3.Set the parameters according to your own coordinate system and save it.
4.Find it in GeoPath.